英语翻译Smart entry system is a system to enable ,without operat

英语翻译
Smart entry system is a system to enable ,without operating the key,to lock/unlock door,to unlatch luggage compartment door,to start engine.It owes interactive communication function of electrical key,which makes the vehicle to recognize where the key is.All that driver has to do is to have the key with him or her.If the electrical key runs out of dry battery,the key operates as mechanical key without the smart key system.
Smart Door Unlock Function
When all the doors are locked,oscillator of each door sends signal regularly and forms detecting area outside of passenger room around 0.7 to 1m from each door handle.After forming the area,driver goes in the area with the electrical key,the key sends ID code signal.Smart key ECU receives signal through electrical key antenna and identifies ID code.After identifying ID code,doors in the area get into unlock stand by condition.At this time,sensors installed in door handles activate.Touching back of door handles unlocks the door locks.
Smart Door Lock Function
If driver gets off the vehicle with the electrical key and pushes lock SW of door handles when all doors are locked,smart key ECU sends signal to inside and outside of passenger room to identify the electrical key.In case identification with inside of the passenger room is NG and that with outside of it is OK,doors lock.
Smart Luggage Compartment Door Unlatch Function
If the driver stands in front of luggage compartment door with the electrical key and pushes unlock SW of luggage compartment door,ID code of the electrical key is identified with smart key ECU through electrical key oscillator (outside luggage room ).After the ID code is identified,luggage compartment door is opened.
Smart Ignition (READY) Function
When the driver pushes the power SW with the electrical key with him or her,ID code of the electrical key is identified with smart key ECU by room oscillator in passenger room.After the ID is identified,engine immobilizer is released and electric power is set at ACCON to enable to start engine.Then pushing the power SW sets power supply at IG ON and another pushing sets it at OFF.Condition circulates from ACC ON to/from IG ON to/from OFF and to OFF and to ACC ON.The vehicle gets READY to drive when the driver pushes power SW with applying brake pedal at any power supply condition.
(to be continued)

我给你翻译完了,可是显示我的内容不适合发送,我郁闷了.我百度嗨你不理我,你查手下站内信,都给你贴过去了、