作业帮 > 英语 > 作业

英语翻译There are some problems with the test of XXXX.When the t

来源:学生作业帮 编辑:作业帮 分类:英语作业 时间:2024/05/06 05:59:30
英语翻译
There are some problems with the test of XXXX.
When the test went to the step E.3.b of the attached test procedure,
“E.3.b With the DC load drawing 5.0A,the LED [D1] should turn on(illuminated) within 10seconds”,
the LED [D1] was not turned on with 10seconds but about 35seconds.
The ripple/noise voltage should remain at lessthan 350mVp-p on the oscilloscope during the test of step E.4 to E.6,
but the ripple/noise voltage we measured was about 400mVp-p which could not reach the request of test procedure.
Could you give someadvice on how to proceed?
We experienced a couple of issues while conducting test XXXX.
When the test reached step E.3.b (see attached test procedure,
“E.3.b With the DC load drawing 5.0A),LED [D1] should turn on(illuminated) within 10seconds”.However,the LED [D1] did not turned on until the 35th second.
The ripple/noise voltage should remain at less than 350mVp-p on the oscilloscope during step E.4 to E.6.However,the ripple/noise voltage measured was around 400mVp-p,which would not pass testing requirements.
Please advise how we should proceed.
国内学校学的英语语法上都没问题,但美国人一般不是这样写.
再问: the ripple/noise voltage measured was around 400mVp-p 去掉We就要做前置定语了. 其它的觉得很好.