multisim中的分析中出现timestep too small 什么情况 怎么样改善
来源:学生作业帮 编辑:作业帮 分类:综合作业 时间:2024/05/10 08:38:13
multisim中的分析中出现timestep too small 什么情况 怎么样改善
怎样调呢?
怎样调呢?
In smaller circuits this error is generally due to a mistake in wiring or connecting components,so this must be checked first.
If the wiring has been validated in the circuit follow these steps:
1.Select Simulation » Interactive Simulation Settings
2.Under Initial conditions select Set to zero
3.Click the OK button
Check to see if the simulation now works.If not:
4.Select Simulation » Interactive Simulation Settings
5.Change Maximum Time Step (TMAX) from 1e-005 to 1e-003
6.Click the OK button
Check to see if the simulation now works.If not:
7.Select Simulation » Interactive Simulation Settings
8.Select the Analysis Options tab
9.Select the Use Custom Setting radio button and click on the Customize button
10.Select the Global tab
11.Set Relative Error Tolerance [RELTOL] to 0.01
12.Set Shunt resistance from analog nodes to ground [RSHUNT] to 1e+9
13.Select the Transient tab
14.Set Integration Method [METHOD] to Gear
15.Click the OK button
16.Click the OK button
In Multisim 10.x and higher the Convergence Assistant conveniently tries to fix this error for you.
If the wiring has been validated in the circuit follow these steps:
1.Select Simulation » Interactive Simulation Settings
2.Under Initial conditions select Set to zero
3.Click the OK button
Check to see if the simulation now works.If not:
4.Select Simulation » Interactive Simulation Settings
5.Change Maximum Time Step (TMAX) from 1e-005 to 1e-003
6.Click the OK button
Check to see if the simulation now works.If not:
7.Select Simulation » Interactive Simulation Settings
8.Select the Analysis Options tab
9.Select the Use Custom Setting radio button and click on the Customize button
10.Select the Global tab
11.Set Relative Error Tolerance [RELTOL] to 0.01
12.Set Shunt resistance from analog nodes to ground [RSHUNT] to 1e+9
13.Select the Transient tab
14.Set Integration Method [METHOD] to Gear
15.Click the OK button
16.Click the OK button
In Multisim 10.x and higher the Convergence Assistant conveniently tries to fix this error for you.
你好!我用protues仿真时出现timestep too small ,这个怎么调呀?
protues 仿真的错误,timestep too small...该怎么办?
Multisim中如何分析一条电路上电流
如果串联中有两个灯泡,如果其中一个灯泡短路会出现什么情况,那断路又会怎么样
许多人常常用什么中的诗句来比喻在复杂情况中出现了解决问题的方法
multisim中的灯是哪个?
电路中什么情况下会出现用电器短路
英语日记中什么情况下可以出现一般现在时
什么情况下一个句子中回出现两个过去式
利用multisim分析分压式偏置放大电路
在Multisim 10 中的 VCC VDD VEE VSS都是什么区别啊?
地震中的父与子 不论发生什么,我中会跟你在一起什么情况下出现 这样写有什么好处